Factory Direct Hardware Hansgrohe 17010 - Manual (Page 3)

3
Install the faucet
Place the faucet and sealing ring on top of the
mounting surface.
Install the mounting flange over the stud. Thread
the collar onto the stud until the mounting flange is
firmly against the bottom of the mounting surface.
mounting
flange
stud
collar
sealing ring
Secure the supply lines to the stop valves with
the 3/8” compression fittings (not included).
Use two wrenches to insure that supply hoses
do not twist.
For proper operation of the faucet, hot
should be on the left, and cold should be on
the right.
Install the drain.
Re-set the high temperature limit stop (if desired). Install the handle.
Turn on the water and check for leaks at all connections.