Factory Direct Hardware Hansgrohe 17010 - Manual (Page 5)

5
Re-set the High Temperature Limit Stop (optional)
Close the drain OR cover it with a wash cloth.
Use a 4 mm Allen wrench to push the screw cover
into the handle. Retrieve the screw cover when
the handle is removed.
Use the 4mm Allen wrench to loosen the handle
screw 4 complete revolutions. Remove the handle
and put it in a safe place.
Replace the high temperature limit stop so
that the pin on the cartridge is in the desired
slot on the limit stop. Note: the temperatures
given in the diagram assume a water
heater temperature of 140
o
F, a cold water
temperature of 50
o
F and a water pressure of
45 PSI.
Remove the decorative nut cover and put it in a
safe place.
Remove the handle screw from the stem of the
cartridge. Remove the high temperature limit stop.
Replace the decorative nut cover. Replace the handle screw. Use the Allen wrench to turn the
screw 4 revolutions.
Replace the handle. Finish tightening the handle screw. Turn on the water and test the faucet.