Factory Direct Hardware Hansgrohe 10458 Axor Starck - Manual (Page 3)

3
Installation
Turn off the water at the main.
Cut the plaster shield so that it extends 3/8" above the
surface of the finished floor.
Use an 8 mm Allen wrench (not included) to remove
the three screws from the flush housing. Remove the
flush housing. Do not disgard the screws.
Place the tub filler on the rough-in (1). Pivot the tub
filler so that the spout faces the correct direction (2).
Use a level to make sure that the unit is straight (3).
Install the tub filler using the three reserved screws
from the flush housing as well as the three screws
included with the tub filler -- six screws total. Tighten
them with the 8 mm Allen wrench (4)
plaster shield
flush housing