Asus LSI SAS3442X-R - Manual (Page 54)

A-6 Using the CFGGEN IR Configuration Utility
Version 1.1 Copyright © 2006, 2007 by LSI Logic Corporation. All rights reserved.
Parameters –
•
<controller #> – Number of the SAS controller targeted by this
command.
•
<volume type> – Volume type for the new volume to be created.
Valid values are IM or IME or IS.
•
<size> – Size of the RAID volume in megabytes, or MAX for the
maximum size available.
•
Bay – This option indicates that enclosure:bay values are specified
instead of SCSI ID values.
•
<SCSI ID> – SCSI ID of a hard disk drive to be included in the RAID
volume.
•
<enclosure:bay> – The enclosure:bay value for the disk drive to be
included in the RAID volume. These values can be obtained from the
output of the DISPLAY command.
•
qsync – If this optional parameter is specified, a quick
synchronization of new volume will be performed. If the volume type
is IME or IS, a quick synchronization is always performed even if
qsync is not specified. A quick synchronization means that the first
32-KB of the drives in the volume are cleared to 0.
•
noprompt – Suppresses display of warnings and prompts.
Program Return Value –
0x00 SUCCESS: command completed successfully.
0x01 FAILURE: bad command line arguments or operational failure.
A.3.3 DEFAULTS Command
Note: This command is called DELETE in the EFI version of
CFGGEN.
The DEFAULTS (DELETE) command deletes any IM, IME, and IS
volumes and hot spare drives created by the CREATE and HOTSPARE
commands. No other controller configuration parameters are changed.