Asus LSI SAS3442X-R User Manual
Page 56
A-8
Using the CFGGEN IR Configuration Utility
Version 1.1
Copyright © 2006, 2007 by LSI Logic Corporation. All rights reserved.
Program Return Value –
0x00
SUCCESS: command completed successfully.
0x01
FAILURE: bad command line arguments or operational failure.
Sample Output –
The following example shows a sample output of the CREATE command
when used to create an IM configuration.
Read configuration has been initiated for controller 0
------------------------------------------------------------------------
Controller information
------------------------------------------------------------------------
Controller type
: LSI1064/1068
BIOS version
: 6.05.05.00
Firmware version
: 0.07.01.00
SCSI channel description
: 1 Serial Attached SCSI
Initiator IDs (SCSI ID)
: 63
Maximum physical devices
: 62
Concurrent commands supported
: 511
Slot
: 1
Bus
: 2
Device
: 2
Function
: 0
------------------------------------------------------------------------
IR Volume information
------------------------------------------------------------------------
IR volume 1
Status of volume
: Okay (OKY)
RAID level
: 1
Size (in MB)
: 34332
Physical hard disks (SCSI ID)
: 10 7
------------------------------------------------------------------------
Enclosure information
------------------------------------------------------------------------
Enclosure #
: 1
Enlcosure WWN
: 12345678:ABCDABCD
Start Slot
: 1
Num Slots
: 4
Start SCSI ID
: 0
------------------------------------------------------------------------
Physical device information
------------------------------------------------------------------------
Initiator at SCSI ID 63
Target on SCSI ID 7
Enclosure #
: 1
Slot #
: 1
Device is a Hard disk
SCSI ID
: 7
State
: Online (ONL)