Asus LSI SAS3442X-R - Manual (Page 55)

CFGGEN Commands A-7
Version 1.1 Copyright © 2006, 2007 by LSI Logic Corporation. All rights reserved.
Command Line –
DOS, Linux, WinPE versions:
cfggen <controller #> defaults [noprompt]
EFI version:
cfggen <controller #> delete [noprompt]
Parameters –
•
<controller #> – Number of the SAS controller targeted by this
command.
•
noprompt – Suppresses display of warnings and prompts.
Program Return Value –
0x00 SUCCESS: command completed successfully.
0x01 FAILURE: bad command line arguments or operational failure.
A.3.4 DISPLAY Command
The DISPLAY command displays configuration information for the
supported SAS controllers. The information includes controller type,
firmware version, BIOS version, volume information, and physical drive
information. An example of the information that will be output by this
command is provided in Sample Output below.
Note: 1 megabyte = 1,048,576 bytes. All sizes displayed in
megabytes are rounded down to the nearest megabyte.
Command Line –
cfggen <controller #> display [filename]
Parameters –
•
<controller #> – Number of the SAS controller targeted by this
command.
•
[filename] – Optional valid filename to store the output of the
command to a file.