Asus TW100-E5 iQuadro - Manual (Page 102)

6-4 Chapter 6: Driver installation
5. Select the RAID controller driver from the list, then press <Enter>.
ENTER=Continue F3=Exit
Windows Setup
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
NVIDIA RAID Driver (required)
NVIDIA nForce Storage Controller (required)
6. The Windows ® Setup loads the RAID controller drivers from the RAID driver
disk. When prompted, press <Enter> to continue installation.
7. Setup then proceeds with the OS installation. Follow screen instructions to
continue.
6.1.4 Installing an operating system
This motherboard supports Windows ® XP/64-bit XP/Vista/64-bit Vista operating
systems (OS). Always install the latest OS version and corresponding updates to
maximize the features of your hardware.
• Motherboard settings and hardware options vary. Use the setup
procedures presented in this chapter for reference only. Refer to your OS
documentation for detailed information.
• Make sure that you install Windows ® XP Service Pack 2 or later versions
before installing the drivers for better compatibility and system stability.
Windows ® Vista OS
To install the RAID controller driver when installing Windows ® Vista OS
1. Insert the floppy disk with RAID driver into the floppy disk drive.
2. During the OS installation, select Load Driver, click Browse, then select
Floppy Disk Drive (A:). Click OK.
3. Select NVIDIA nForce RAID controller (A:\nvrd32.inf) and click Next.
4. Follow the succeeding screen instructions to complete the installation.