Asus RS926-E7/RS8 - Manual (Page 40)

Chapter 2: Hardware setup 2-18
Pre-connected system cables
1. 24-pin SSI power connector (from power supply to motherboard)
2. 8-pin SSI power connector (from power supply to motherboard)
3. System fan connectors (from motherboard FRNT_FAN1, FRNT_FAN2
FRNT_FAN3, FRNT_FAN4, and FRNT_FAN5 to system fans)
4. USB connector (from motherboard to front I/O board)
5. Power Supply SMBUS connector
6. Auxiliary Panel connector (from motherboard to front I/O board)
7. Panel connector (from motherboard to front I/O board)
8. SATA connectors (from motherboard to SATAII/SAS backplane board)
9. SAS connector (from motherboard to SATAII/SAS backplane board)
10. SGPIO 1 (Intel RAID)
11. PSGPIO 1,2 (LSI PIKE RAID)
2.6 Cable connections
• The bundled system cables are pre-connected before shipment. You do
not need to disconnect these cables unless you will remove pre-installed
components to install additional devices.
• Refer to Chapter 4 for detailed information on the connectors.
9
1
2
4
5
7
3 3 3 3 3
8
8
6
10
11