Asus RS926-E7/RS8 - Manual (Page 97)

ASUS RS920-E7/RS8; RS926-E7/RS8 5-21
SATA Mode [AHCI Mode]
Allows you to set the SATA configuration.
Configuration options: [Disabled] [IDE Mode] [AHCI Mode] [RAID Mode]
• If you want to use the Serial ATA hard disk drives as Parallel ATA physical
storage devices, set this item to [IDE Mode].
• If you want the Serial ATA hard disk drives to use the Advanced Host
Controller Interface (AHCI), keep the default setting [AHCI Mode]. The AHCI
allows the onboard storage driver to enable advanced Serial ATA features
that increases storage performance on random workloads by allowing the
drive to internally optimize the order of commands.
• If you want to create RAID sets with LSI MegaRAID utility, or Intel ® Rapid
Storage Technology Enterprise from the Serial ATA hard disk drives, set this
item to [RAID Mode].
S.M.A.R.T. Status Check [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor
system. When read/write of your hard disk errors occur, this feature allows the hard
disk to report warning messages during the POST.
Configuration options: [Enabled] [Disabled]
Staggered Spin-up [Disabled]
Staggered spin-up is a feature defined in the Serial ATA Specifications. It enables
an HBA to individually spin-up attached SATA devices to avoid maximum current
charged by applying all attached SATA devices at the same time.
Configuration options: [Disabled] [Enabled]