Asus WL-300g - Manual (Page 39)

3. Software
ASUS 802.11g Access Point 39
Chapter 3 - Software Configuration
Home Gateway
To set up your wireless interface,
you must first give it an SSID
(Service Set Identifier). The SSID
is a unique identifier attached to
packets sent over WLANs. This
identifier emulates a password
when a wireless device attempts
communication on the WLAN.
Because an SSID distinguishes
WLANs from each other, access
points and wireless devices trying
to connect to a WLAN must use the
same SSID.
Also, if you want to protect transmitted data, select a middle or high Security
Level.
Medium: Only allows those users with the same WEP key to connect to
this access point and to transmit data using 64-bit WEP or 128-bit WEP
encryption.
High: Only allows those users with the same WPA pre-shared key to connect
to this access point and to transmit data using TKIP encryption.
Click Finish to continue. You are prompted to save the settings. Click
Save&Restart to save the settings to the ASUS 802.11g AP and enable the
new settings.
Home Gateway Mode (Cont.)