Asus KFN5-Q/SAS - Manual (Page 81)

ASUS KFN5-Q Series 4-11
4.3.4 IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press <Enter>
if you wish to configure the item.
DISABLED: disables
the intergrated IDE
Controller.
PRIMARY: enables
only the Primary IDE
Controller.
IDE Configuration
OnBoard PCI IDE Controller [Both]
Serial-ATA Devices [Device 0/1/2]
nVidia RAID Setup
Primary IDE Master : [Not Detected]
Primary IDE Slave : [Not Detected]
Serial-ATA 0 Primary Channel : [Not Detected]
Serial-ATA 0 Secondary Channel : [Not Detected]
Serial-ATA 1 Primary Channel : [Not Detected]
Serial-ATA 1 Secondary Channel : [Not Detected]
Serial-ATA 2 Primary Channel : [Not Detected]
Serial-ATA 2 Secondary Channel : [Not Detected]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host & Device)
OnBoard PCI IDE Controller [Enabled]
Enables or disables primary IDE controllers.
Configuration options: [Disabled] [Enabled]
Serial-ATA Devices [Device 0/1/2]
Enables or disables the SATA0/1/2 IDE interfaces.
Configuration options: [Disabled] [Device 0] [Device 0/1] [Device 0/1/2]
nVidia RAID Function [Disabled]
Enables or disables the nVidia RAID function.
Configuration options: [Disabled] [Enabled]
nVidia RAID Setup
This menu enables you to enable or disable RAID mode for each ATA
channhels while entering setup.
nVidia RAID Function [Disabled]
Enabled
Disabled
Options