Armasight CO-X GEN 3 Ghost Night Vision Clip-On System - Manual (Page 15)

15
2.3 STANDARD COMPONENTS
The CO-X standard components are shown in Figure 2-3 and listed in Table 2-10.
The ITEM NO. column indicates the number used to identify items in Figure 2-3.
FIGURE 2-3. STANDARD COMPONENTS
1
2
3
4 5
6 8
9 10
11
13
7
14
15
12
TABLE 2-10. STANDARD COMPONENTS
ITEM NO. DESCRIPTION qUANTITY
1 CO-X Night Vision Clip-On System
A night vision device intended for use in conjunction with a day scope.
1
2 Single Lever-Lock quick Release Picatinny Mount #27
A quick release mount used to install the CO-X on a Picatinny/ Weaver rail.
1
3 М4×8 Flat Head Socket Cap Screw
Used for attaching the mount or the optional Weaver rail to the CO-X.
2
4 Advanced Wireless Remote Control
Wireless control used to operate the CO-X in short-time activation mode. Ensures
quick and silent CO-X activation/deactivation. Delivered with two CR2016 (3V)
batteries installed.
1
5 Picatinny Adaptor for Advanced Wireless Remote Control
A adaptor mounted to the Picatinny rail of an weapon. Allows the Advanced Wire-
less Remote Control to be installed on the weapon.
1
6 Light Suppressor 1
A rubber cup mounted to the CO-X output lens to reduce light scattering. Used
when installing the CO-X in front of day scopes with lens housing outer diameter
over the range 25.4 to 42 mm.
1
7 Light Suppressor 2
A rubber cup mounted to the CO-X output lens to reduce light scattering. Used
when installing the CO-X in front of ACOG 4×32 scope.
1
8 Light Suppressor 3
A rubber cup mounted to the CO-X output lens to reduce light scattering. Used
when installing the CO-X in front of day scopes with lens housing outer diameter
over the range 47 to 50 mm.
1