Armasight CO-X GEN 3 Ghost Night Vision Clip-On System - Manual (Page 26)

26
ITEM NO. CONTROL/INDICATOR FUNCTION
- Remote Control
Button Activates/deactivates the CO-X in standby when pressed/released.
* For CO-X MG model only
3.2.2 IR-850 CONTROLS
The IR850 controls are shown in Figure 3-15 and defined in Table 3-2. The ITEM NO. column indicates the
number used to identify items in Figure 3-15.
TABLE 3-2. IR850 CONTROLS
ITEM NO. CONTROL/INDICATOR FUNCTION
1 Power Switch Switches the IR850 on/ off and adjusts for radiated power. Four on-posi-
tions are located between two OFF positions, and are each marked with a
different-sized spot. The larger the spot, the greater the radiated power.
2 Lens Adjusts for IR beam divergence. Adjustment range is covered with ap-
proximately one turn of the lens.
3.3 OPERATING PROCEDURES
3.3.1 OPERATING THE CO-X
Operating procedures should be performed in night light conditions only.
CAUTION:
Use of the CO-X in brightly lit conditions may damage the image intensifier tube.
CAUTION:
Pay attention to the caution notice on the objective lens cap: “DO NOT REMOVE IN DAYLIGHT”.
CAUTION:
Remember that external light indication is one of the factors which make you detectable. Mask
the LED indicator with the cap, if necessary.
FIGURE 3-15. IR850 CONTROLS
B
A
TABLE 3-1. CONTINUED