Armasight CO-X GEN 3 Ghost Night Vision Clip-On System - Manual (Page 21)

21
3.1.5 INSTALLING THE CO-X ON THE LENS OF A DAY SCOPE
Use the optional Scope Mounting System (SMS) to install the CO-X on the lenses of day scopes.
NOTE :
The adapters differ in attaching diameters and must fit with the day scope parameters specified
in Table 2-9 (Scope Mounting Systems Data).
NOTE :
The CO-X cannot be attached to the scope having a focus ring on the objective lens’ housing.
CAUTION :
The Scope Mounting Systems are not recommended for installing the CO-X on firearms having
vigorous recoil (0.308 Win or stronger).
The CO-X installed on the lens of a day scope is shown in Figure 3-6.
FIGURE 3-6. THE CO-X INSTALLED ON THE LENS OF A DAY SCOPE
Install the CO-X on the lens of a day scope as follows (refer to Figure 3-7):
1. Using a 2.5 mm Allen key, unscrew the both М4×8 screws fixing the CO-X mount. Remove the mount
from its seating rail and put it with the screws into the storage case.
2. Take off the output lens cap and put it into the storage case.
3. With the nut (B) loosened, place the insert (C) into the SMS’s clamp (A).
FIGURE 3-7. SCOPE MOUNTING SYSTEM
A F
E
d
B
C