Armasight CO-X GEN 3 Ghost Night Vision Clip-On System - Manual (Page 22)

22
4. Screw the SMS into the CO-X’s output lens thread.
5. With the nut (B) loosened, slide the CO-X with the SMS onto the lens of the day scope as far as it
goes.
6. Tighten the nut (B) using a screwdriver.
If the position of the SMS’s clamping nut is unhandy, it is possible to change it as follows:
1. Decide on desirable position of the nut and estimate the angle through which the SMS should be
turned CW (see Figure 3-8).
2. Remove the SMS from the CO-X.
3. Using a screwdriver, remove the both M2×2.5 screws (F, see Figure 3-7) and then unscrew the ring
(E).
CAUTION :
To loosen the ring (E), only use its two auxiliary non-threaded holes (D), avoiding the use of the
threaded ones.
4. Using a turning machine, cut the inside face of the ring (E). The value of cutting (in millimeters) is
equal to the value of turning angle (in angular degrees) divided by 360°.
5. Screw the ring (E) into the SMS’s body with its cut end directed inwards and tighten it.
6. After applying a small amount of thread lock to the threads, affix the ring (E) with the two M2×2.5
screws (F).
3.1.6 INSTALLING THE PLATFORM RING ON A DAY SCOPE
The platform ring installed on a day scope is shown in Figure 3-3.
Install the platform ring on the mounting tube of the day scope as follows (refer to Figure 3-9):
1. Using a 3 mm hex key, unscrew the both clamp screws (C).
FIGURE 3-9. PLATFORM RING
A
B
C
d
E
FIGURE 3-8. ESTIMATION OF THE SMS TURNING ANGLE
NUt
dESIRABLE POSItION
OF thE NUt