Armasight NSMNYX14P1F6DA1 NYX-14 Pro FLAG Night Vision Monocular - Manual (Page 20)

20
2. Loosen the screw (A). While pushing down on the button (B), insert the Nyx-14 PRO rail into the guide
(C) of the goggle kit bracket. Tighten the screw (A). See Figure 3-2; the unit is shown in the correct
positioning for the right eye.
3. Put on the goggle kit, now mounted with the Nyx-14 PRO.
4. To adjust the equipment for greater comfort, loosen the screw (A) and move the unit along the guide
(C).
5. The goggle kit has a flip-up mechanism. Push the button (D) of the goggle kit bracket and lift the
unit up until it reaches its highest position. The unit will automatically turn off when it reaches this
position.
6. Push the same button (D) to lower the unit into the correct viewing position. Turn the unit back on
to continue your session.
Figure 3-2 shows the Nyx-14 PRO in the correct position for the right eye. To readjust the unit for the
other eye, remove the unit from the goggle kit bracket. Turn the unit around (180º) and mount it on the
bracket through the rail on the second side. With the button (E) pushed, move the unit along the slide-
rail (F) until the desired or most comfortable position is reached.
To remove the Nyx-14 PRO from the goggle kit, loosen the screw (A), push the button (B), and slide the
unit out of the bracket guide (C)..
C
D
E
F
B
A
FIGURE 3-2. MOUNTING NYX-14 PRO TO A GOGGLE KIT
3.1.3 MOUNTING THE NYX-14 PRO TO A HELMET
An optional flip-up helmet mount can be used to attach the Nyx-14 PRO to a helmet. The helmet mount
fits the Nyx-14 PRO securely onto helmet via a rugged strapping device and grooved hooks. With the
helmet mount, the Nyx-14 PRO can be positioned directly in front of the user’s eyes, or flipped back-
wards, out of the field of view.
Mount the Nyx-14 PRO to a helmet as follows:
1. Attach the mount to the helmet as shown in Figure 3-3.
2. Adjust and tighten the straps (A).
3. Loosen the screw (B). With the button (C) pushed down, insert the Nyx-14 PRO rail into the guide (D)
of the helmet mount bracket. Tighten the screw (B).
4. Put on the helmet with the Nyx-14 PRO attached.
5. Push the button (F) and move the unit along the slide-rail (G) until the most comfortable position is
reached.