Armasight NSMNYX14P1F6DA1 NYX-14 Pro FLAG Night Vision Monocular - Manual (Page 25)

25
3.1.10 MOUNTING ACCESSORY LENSES TO THE NYX-14 PRO
To mount the 3X afocal lens (A) to the device, screw it into the threading of the standard 1X objective
lens on the Nyx-14 PRO.
To mount the 5X (B) or 8X (C) lens, unscrew the existing 1X objective lens of the Nyx-14 PRO and screw
in the 3X, 5X or 8X lens in its place.
The Nyx-14 PRO configured with an 8X lens can be installed on a tripod. To mount the unit on a tripod,
use the 1/4’’ threaded socket (D) on the housing of the 8X lens.
D B C
FIGURE 3-10. MOUNTING ACCESSORY LENSES TO NYX-14 PRO
A
NOTE:
The unit may be badly damaged if the tripod collapses or overturns. Remove the unit from the
tripod if it is not within your reach.
3.1.11 MOUNTING THE NYX-14 PRO TO A WEAPON WITH AN AIM
ADVANCED AIMING MOUNT
The clamping system of the AIM advance aiming mount (AIM) is the same as is seen on the QRM. To
mount the Nyx-14 PRO to a weapon with an AIM, see Part 3.1.5 of this Manual. This section details
mounting instructions and procedures for the QRM.
For more information on the use of an AIM, see the AIM User’s Manual.
FIGURE 3-11. MOUNTING THE NYX-14 PRO TO A WEAPON WITH AN AIM
3.1.12 MOUNTING A CAMERA/ CAMCORDER TO THE NYX-14 PRO
To mount any 35mm SLR photographic camera or 8mm camcorder to the Nyx-14 PRO, use the optional
camera adapter and perform the following:
1. Using the (M37x0.75 threaded) adapter ring (B), screw the (M52x0.75 threaded) adapter (A) into the
front lens of the photographic camera or video camera.
2. Remove the eyecup from the Nyx-14 PRO eyepiece.
3. Connect the adapter with the eyepiece and tighten the three fixing screws (C) located on the adapt-
er.