Armasight NSMNYX14P1F6DA1 NYX-14 Pro FLAG Night Vision Monocular - Manual (Page 22)

22
D
D
B
A
A
FIGURE 3-4. MOUNTING THE NYX-14 PRO TO A WEAPON WITH A PICATINNY MOUNT ADAPTER
C
A
C
3.1.5 MOUNTING THE NYX-14 PRO TO A WEAPON WITH A qUICK-RELEASE
PICATINNY MOUNT ADAPTER
To mount the Nyx-14 PRO to a weapon using an optional quick-release Picatinny mount adapter (QRM),
do the following:
1. While pushing down on the lever holder (C), turn the lever (B) backwards to loosen the QRM clamp-
ing device (A).
2. Install the QRM on the weapon rail by inserting the stop (not shown in Figure 3-5) into one of trans-
verse slots of the weapon rail.
3. To secure the QRM onto the weapon rail, turn the lever (B) forward. Secure the clamping device (A)
tightly to the weapon rail. To adjust the force of the lever clamp, loosen or tighten the nut (D) as neces-
sary.
4. While pushing down on the lever holder (F), turn the lever (E) forward.
5. Install the Nyx-14 PRO on the QRM rail by inserting the stop (G) into the transverse slot of the rail.
6. Attach the Nyx-14 PRO to the QRM rail by turning the lever (E) backwards. Secure the QRM clamping
device (H) tightly to the Nyx-14 PRO rail. To adjust the force of the lever clamp, loosen or tighten the
nut (I) as necessary.
A
B
F
D
B
A
FIGURE 3-5. MOUNTING THE NYX-14 PRO TO A WEAPON WITH A qUICK-RELEASE
PICATINNY MOUNT ADAPTER
E
C
D
G
I
H
E
3.1.6 MOUNTING THE NYX-14 PRO TO A SCOPE
To mount the Nyx-14 PRO to a daytime scope using an optional flip-up scope adapter, do the follow-
ing:
1. Loosen the adapter’s fixing screw (A).
2. Install the insert into the adapter (Armasight supplies inserts of different sizes for coupling with 38-
43mm eyepieces).