Armasight NSMNYX14P1F6DA1 NYX-14 Pro FLAG Night Vision Monocular - Manual (Page 24)

24
3.1.8 MOUNTING AN IR ILLUMINATOR TO THE NYX-14 PRO
To mount an IR illuminator to the Nyx-14 PRO, use the optional Dovetail to Weaver Transfer Piece. Per-
form the following steps:
1. Install the transfer piece (A) onto one of the Nyx-14 PRO rails.
2. Tighten the two fixing screws (B) on the transfer piece.
3. Loosen the IR illuminator fixing screw (C).
4. Mount the IR illuminator on the Weaver rail of transfer piece and tighten the fixing screw (C).
B
C
FIGURE 3-8. MOUNTING AN IR ILLUMINATOR TO THE NYX-14 PRO
A
3.1.9 MOUNTING THE NYX-14 PRO TO A STANDARD US MIL HELMET/ HEAD-
GEAR ASSEMBLY
To mount the Nyx-14 PRO to a Standard US Mil helmet or headgear assembly, use an optional transfer
adapter. Perform the following steps:
1. Push down on the lever (C). Mount the adapter (A) to the Nyx-14 PRO rail (B).
2. Align the adapter prism (D) with the helmet/ headgear assembly mount (E). Slide the Nyx-14 PRO
backwards until its alignment boss is in line with the alignment groove on the helmet/ headgear as-
sembly mount. Push down until the Nyx-14 PRO locks into the helmet/ headgear assembly mount.
To dismount the Nyx-14 PRO from the helmet/ headgear assembly, push down on the lever (F) and
remove the unit.
Push down on the lever (C) and remove the adapter from the Nyx-14 PRO rail.
The transfer adapter can be adjusted for either the right or left eye. In Figure 3-9, the Nyx-14 PRO is
shown in the proper position for the left eye. Readjust the adapter for the right eye as follows:
— Push down on the lever (C). Remove the adapter from the Nyx-14 PRO rail.
— Loosen the nut (G), and turn the adapter around between the two fixing devices. Retighten the nut
(G).
— Mount the adapter to the other Nyx-14 PRO rail located on the opposite side of the unit.
A
C
FIGURE 3-9. MOUNTING NYX-14 PRO TO STANDARD US MIL HELMET/HEADGEAR ASSEMBLY
B
G
D F
F C
E
D
D