Xylem IM253 R0 AquaStart Combination Soft Starters - Manual (Page 10)

10
PROGRAMMING VIA DIP SWITCHES AND TRIM POTS:
To program DI2 for 3-wire control, refer to Figure 5 and perform the following:
1. Press and hold the reset button on the front of the SSW07 for 5 seconds to enter the programming mode.
Note: The reset button must remain pressed during programming.
2. When the programming mode is entered, two LED’s will illuminate (over-current and phase loss), indicating
that DI2 is programmed for fault reset.
3. To re-program for 3-wire control, switch the over-current dip-switch and return to the previous position.
Three LED’s will illuminate (over-current, phase loss, and phase sequence), indicating that DI2 is now
programmed for 3-wire control.
4. To change DI2 programming back to fault reset, switch the kick start dip-switch and return to the previous
position. Two LED’s will illuminate (over-current and phase loss), indicating that the DI2 is programmed for
fault reset.
5. Release the reset button to complete the programming.
FIGURE 7 – Trim-Pots and Dip Switch Locations