Xylem IM253 R0 AquaStart Combination Soft Starters - Manual (Page 4)

4
BASIC WIRING
1. Mount the AquaStart panel to a flat vertical surface.
2. Connect the three-phase incoming power leads to the R, S, and T connections on the power terminal (refer
to Figure 1). Connect the motor leads to the U, V, and W connections on the power terminal and connect
the GROUND lead to PE on the chassis (refer to Figure 1). Note: Only three-phase AC motors can be
used.
USING THE KEYPAD (OPTIONAL)
The keypad can be used in the following arrangements:
• Keypad on controller:
o Local keypad is attached to the SSW07 controller for commanding, programming, and/or visualizing
parameters.
• Keypad on door:
o Remote keypad is mounted “through door” attached to the SSW07 controller with a cable for
commanding, programming, and/or visualizing parameters.
The SSW-07 local or remote keypads present a 7-segment 4-digit LED display, 4 status LEDs, and 8 keys. The
figures below show a front view of the remote keypad and the local keypad.
BASIC FUNCTIONS OF THE KEYS:
Enables the motor (start);
Disables the motor (stop), Resets the
Soft-Starter after the occurrence of
errors;
Selects (toggles) the display between
the parameter number and its value
(position/content);
Increments the parameter number or
parameter value;
Decrements the parameter number or
parameter value;
Selects the origin of the commands
between Local or Remote;
No Function on SSW-07
No Function on SSW-07
REMOTE KEYPAD LOCAL KEYPAD FRONT VIEW
FIGURE 2 – Keypads