3 stopping a temperature program, Stopping a temperature program – YSI CR2200 Thermoreactor User Manual
Page 21
CR 2200
Operation
21
ba76119e01
08/2012
The thermoreactor is in the program selection mode.
As soon as the thermoblock has cooled down to under 50°C, the
control lamps switch themselves off.
5.3
Stopping a temperature program
You can terminate a running program at any time.
Note
While STOP? is displayed the temperature program goes on running.
As soon as a section of the temperature program is finished (e.g. after
the end of the heating period or after the end of the reaction time), the
STOP? display is overwritten.
1
Using 4 6, terminate the running temperature program.
The control lamp for the thermoblock flashes red/green.
The safety query STOP? is displayed.
2
Using g confirm the safety query STOP?.
The temperature program is finished.
The control lamps of the thermoblock will then light up green.
or:
Using 4 6, leave STOP?.
The query STOP? disappears from the display. The
temperature program is continued.