YSI CarboVis 705 IQ - Manual (Page 20)

Commissioning
CarboVis 70x IQ
3 - 10 ba75950e02 11/2012
Measuring mode

COD spectr., total
 COD spectr., dissolv
 TOC spectr., correl.
 BOD spectr., correl.

DOC spectr., correl.

SAC 254, total

SAC 254, dissolved
 UVT 254
The measured parameter is displayed
in the selected citation form.
When changing the Measuring mode
setting, always check the Measuring
location setting.
If the previously set measurement loca-
tion is not available for the selected
measuring mode, the measurement
location is automatically changed..
Measuring location  Outlet
 Inlet
 Activation
CarboVis 701 IQ :

Activation

Inlet

Outlet
CarboVis 705 IQ
:
 Outlet
(permanently set)
Measurement location or application of
the sensor.

The possible measurement loca-
tions are displayed depending on the
currently set measuring mode.
 The sample matrix on which the cal-
culation of the measured value is
based changes with the location of
the sensor.
The measurement location Activation
can only be selected for Measuring
mode COD spectr., dissolv .
When the measurement location is
changed, all virtual sensors are
deleted.
Measuring range - Display of the measuring range
(see chapter 8 T
ECHNICAL DATA
).
Cal - # raw value 1 Value pairs of the user calibration (see section 4.3.2).
Note: Leave those values unchanged during the initial commission-
ing.
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2
Number of N-sensors
Number of C-sensors
1 ... 2
10 ... 43
Apart from the main sensor, up to 4
more sensors can be displayed.
The settings for the additional sensors
are done in the menus for the respec-
tive sensors.
Zero adjustment Factory
User
Setting of which zero adjustment is
used in the sensor.

Factory zero adjustment or
 Zero adjustment carried out last
Menu item Settings Explanations