Connecting lines to the terminal strip, Installation miq/c6 3 - 4, Current outputs – YSI IQ S ENSOR N ET MIQ/C6 User Manual
Page 12
Installation
MIQ/C6
3 - 4
ba76033e01
01/2012
Connecting lines to the
terminal strip
Fig. 3-1
Terminal strip with the current connections
1
Open the module.
2
Open the dummy screw fitting under the required connection.
Keep the dummy screw fitting for possible later modifications.
3
Screw the cable gland (pos. 1 in Fig. 3-1) with the sealing ring
(pos. 2) into the module housing.
4
Loosen the coupling ring (pos. 3 in Fig. 3-1).
5
Feed the line through the cable gland in the module housing.
6
Connect the wires to the terminal strip. While doing so, pay
attention to the specifications on the label located under the
terminal strip.
7
Tighten the coupling ring (pos. 3 in Fig. 3-1).
8
Close the module.
1
3
2
Current outputs
X18
+ REC3 -
+ REC6 -
+ REC2 -
+ REC5 -
SENSORNET 2
SENSORNET 1
+ REC1 -
+ REC4 -
ON
OFF
0/4...20mA
0/4...20mA
0/4...20mA
0/4...20mA
0/4...20mA
0/4...20mA
X17
X16
X15
X14
X13
X12
X11
X10
X8
X9
X7
X6
RED
RED
SN
TERMINA
TO
R
GREEN
SHIELD
GREEN
X5
X4
X3
X2
X1
SHIELD