Extron Electronics FOXBOX Tx_Rx HDMI User Guide - Manual (Page 27)

Command/response table for Transmitter SIS commands (continued)
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Audio input gain and attenuation
NOTES: • The set gain (G) and set attenuation (g) commands are case sensitive. The increment level, decrement level, and show level are
not case sensitive.
• When the controlling PC is connected to the receiver, the PowerCage FOX can perform this command only if the receiver-Tx-to-
transmitter-Rx fiber cable is connected. The unit returns the E14 error if the Rx fiber is not connected.
Set input audio gain to a
+dB value X^ G Aud X&] Set the input level to X& dB (gain).
Example: 2G Aud+02.0 ] Set the input level to +2 dB (gain).
Set input audio attenuation
to a -dB value X* g Au d X&] Set the input level to X& dB (attenuation).
Increment input level +G Aud X&] Increase the audio level by 1 dB.
Example: +G Aud+03.0 ] Increment the input level from +2 dB to +3 dB.
Decrement input level –G Aud–01.0 ] Decrease the audio level from 0 dB to –1 dB.
Show input level G X&]
Plus mode transmission
NOTE: Plus mode forces the transmitter to emulate a FOXBOX DVI Plus or PowerCage FOX DVI Plus transmitter) .
Enable Plus mode 81*1# Plus1 ] Turn on Plus mode (default).
Disable Plus mode 81*0# Plus0 ] Turn off Plus mode.
View Plus mode 81# X(] Show Plus mode status.
Input reports as an HDCP authorized device
HDCP authorized device on E E1HDCP } HdcpE1 ] Set the transmitter as an HDCP authorized device.
HDCP authorized device off E E0HDCP } HdcpE0 ] Set the transmitter as not an HDCP authorized device.
View HDCP authorized
device status E EHDCP } X1)] Show HDCP authorized device status.
Status requests
View link 1 (Tx-to-Rx) status 1S X1!]
View link 2 (Rx-to-Tx) status 2S X1!]
View input video status 3S X1!]
View input audio status 4S X1!]
View all signal status 5S SigI X1! • SigO X1! • HdcpI X1! • HdcpO X1!]
Report the status of the HDMI input, HDMI output,
HDCP encoding on the input, and HDCP encoding
on the output.
View HDMI signal status 6S SigI X1! • SigO X1!] Report the status of the HDMI input and HDMI
output (always -- for a transmitter).
View HDCP status 7S HdcpI X1! • HdcpO X1!] Report the status of the HDCP encoding on the
input and HDCP encoding on the output.
View temperature 20S X1@ F • X1@ C ] Show temperature in degrees Fahrenheit and Celsius.
NOTE: X^ = Audio gain adjustment range 00 to 10
X& = Audio level adjustment range -18 to +10 (in 1.0 dB steps)
X* = Audio attenuation adjustment range 00 to 18
X( = Enable or disable status 0 = off (down) or disable 1 = on (up) or enable
X1) = HDCP authorized device 0 = off 1 = on
X1! = Link and input status 0 = link or input not detected 1 = link or input detected
X1@ = Internal temperature nnnF•nnC
FOXBOX Tx/Rx HDMI • Remote Control 21