Extron Electronics FOXBOX Tx_Rx HDMI User Guide - Manual (Page 42)

Reference
Information
This section discusses the specifications, part numbers, and accessories for the
FOXBOX Tx/Rx HDMI. Topics that are covered, include:
• Specifications
• Part Numbers
• Mounting the Units
Specifications
NOTES: • The analog audio signal(s) is (are) digitized in the transmitter, sent through the fiber cable, and
converted back to analog audio in the receiver.
• These transceivers are class 1 laser products. They meet the safety regulations of IEC-60825,
FDA 21 CFR 1040.10, and FDA 21 CFR 1040.11.
Optical fiber interconnection between transmitter and receiver
Number/type .................................. 2 fiber optic
Connectors .................................... 2 LC connectors
Operating distance
Singlemode ............................. 30 km (18.75 miles) with singlemode (SM) cables with a FOXBOX SM
Multimode ............................... 300 m (985') with 62.5 µm OM1 multimode (MM) cables with a FOXBOX MM
1 km (3280') with 50 µm OM2 multimode (MM) cables with a FOXBOX MM
2 km (6561') with 50 µm OM3/OM4 2000 MHz bandwidth laser optimized
multimode cable with a FOXBOX MM
NOTE: Operating distance is approximate. These are typical maximum distances that may vary depending on
factors such as fiber type, fiber bandwidth, connector splicing, losses, modal or chromatic dispersion,
environmental factors, and kinks.
Nominal peak wavelength .............. 850 nm for FOXBOX MM, 1310 nm for FOXBOX SM
Data rate ........................................ 4.25 Gbps
Transmission power
Singlemode ............................. -5 dBm, typical
Multimode ............................... -5 dBm, typical
Maximum receiver sensitivity
Singlemode ............................. -18 dBm, typical
Multimode ............................... -12 dBm, typical
Optical loss budget
Singlemode ............................. 13 dB, maximum
Multimode ............................... 7 dB, maximum
36 FOXBOX Tx/Rx HDMI • Reference Information