Extron Electronics FOXBOX Tx_Rx HDMI User Guide - Manual (Page 36)

HDCP area
NOTE: • The HDCP Authorized controls are available only if
you are connected to the transmitter.
• The HDCP Notification controls are available only if
you are connected to the receiver.
Both sets of radio buttons cannot be available for
selection at the same time.
HDCP Authorized radio buttons — The HDCP authorized function determines whether
the transmitter operates as an HDCP authorized device or not. An HDCP authorized device
allows an HDMI source to output HDCP-encrypted video. A non-authorized setting is useful
for video sources that always encrypt their output if the connected device (the transmitter
in this example) is HDCP capable. If the display connected to the receiver is not HDCP
compliant, this automatic encryption would result in no display.
HDCP Notification radio buttons — The HDCP notification function in the receiver
enables a connected display to show a green or black screen if the transmitted HDMI video is
HDCP encrypted and the display is not HDCP capable.
Assigned EDID area
NOTE: The Assigned EDID area control is available only if you
are connected to the transmitter and the transmitter
front panel EDID Minder hex switch is in position 1.
If the hex switch is not in position 1, the Assigned
EDID area advises you “To change EDID, set
rotary switch from #n to #1.“
The Assigned EDID area provides a drop-down box that let you
manually set the EDID resolution and refresh rate and reports the
position of the transmitter front panel EDID Minder hex switch.
Save EDID area
NOTE: The Save button is available only if you are connected
to the transmitter.
The Save EDID button lets you save the EDID resolution and refresh rate from the transmitter
HDMI Loop Thru monitor. The data is saved to the user-captured EDID location (front panel
EDID Minder hex switch position 0).
Plus Mode Transmission area
NOTE: The Plus Mode Transmission radio buttons are available only
if you are connected to the transmitter.
The Plus Mode Transmittion radio buttons allow you to enable and disable Plus mode.
• Enabled forces the transmitter to emulate a FOXBOX DVI Plus or PowerCage FOX DVI
Plus transmitter for compatibility with one of four receivers: a FOXBOX HDMI Rx, a
FOXBOX DVI Plus Rx, a PowerCage HDMI Rx, or a PowerCage FOX DVI Plus Rx.
• Disabled allows the output of the transmitter to be received by any FOXBOX,
PowerCage FOX, and FOX 500 VGA and DVI unit, including the Plus and non-Plus units.
FOXBOX Tx/Rx HDMI • Remote Control 30