Extron Electronics FOXBOX Tx_Rx HDMI User Guide User Manual
Page 40
2.
If you have not previously updated firmware for the FOXBOX unit before, on the Add
Device screen (see figure 22), select the RS-232 tab.
Figure 22.
Add Device Screen
If you have previously updated firmware for this model, click Cancel. The Firmware
Loader window appears. Proceed to step 5.
NOTE: Although the screen also has a TCP/IP tab, the FOXBOX unit does not have a
LAN port. Do not select the TCP/IP tab.
3.
From the drop-down menus on the RS-232 screen, select the appropriate Com port
number and baud rate (the default is 9600).
4.
Click OK. The Firmware Loader window appears (see figure 23).
5
Figure 23.
Extron Firmware Loader Window
5.
Select the FOXBOX unit and click File > Open. The Choose Firmware File screen
appears (see figure 24).
6
6
Figure 24.
Choose Firmware File Window
FOXBOX Tx/Rx HDMI • Remote Control
34