Extron Electronics FOXBOX Tx_Rx HDMI User Guide - Manual (Page 29)

Symbol definitions for receiver SIS commands
]
= Carriage return/line feed
}
= Carriage return (no line feed)
| = Pipe (can be used interchangeably with the
}
character)
• = Space (hard) character
E
= Escape key (hex 1B)
W = Can be used interchangeably with the
E
character
X(
= Mute/auto memory status and enable or disable status 0 = off or disable 1 = on or enable
X1!
= Link and input status 0 = link or input not detected 1 = link or input detected
X1@
= Internal temperature nnnF•nnC
X1#
= Transmission mode SM = singlemode MM = multimode
X1$
= Firmware version v.vv
X1%
= Switch position 0 = off (right) 1 = on (left)
X1^
= Horizontal and vertical position 000 through 255
X1&
= Sync frequency xxx.xx (frequency in kHz [H] or Hz [V])
X1*
= Memory preset number 01 to 30
X1(
= Test pattern 0 = none 2 = grayscale
1 = color bars 3 = alternating pixels
X2)
= Rx link and daisy chain enable 0 = disable 2 = daisy chain enable
1 = return link enable
X2!
= Video delay (0 plus six steps at 0.25 seconds per step) 0 = 0 second
1 = 0.25 second
4 = 1.0 second
2 = 0.5 second (default) 5 = 1.25 second
3 = 0.75 second 6 = 1.5 second
X2@
= Video bit depth 0 = auto 1 = 8-bit
Command and Response Table for Receiver SIS Commands
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Video mute
Mute output 1B Blk1 ] Blank the video output.
Unmute output 0B Blk0 ] Output video.
Show video mute status B X(] Video mute status is X( .
Horizontal shift
Set a horizontal position X1^ H Hph X1^] Set horizontal centering to X1^ .
Increment position +H Hph X1^] Shift the image one pixel to the right.
Decrement position –H Hph X1^] Shift the image one pixel to the left.
Show position H X1^]
Vertical shift
Set a vertical position X1^ / Vph X1^] Set vertical centering to X1^ .
Increment position +/ Vph X1^] Shift the image down one line.
Decrement position –/ Vph X1^] Shift the image up line.
Show position / X1^]
List sync frequency
View input frequency 1LS X1& , X1&] List the input sync frequency as X1& kHz (horizontal)
and X1& Hz (vertical).
NOTE: X( = Mute and auto memory status 0 = off 1 = on
X1^ = Horizontal and vertical position 000 through 255
X1& = Sync frequency xxx.xx (frequency in kHz [H] or Hz [V])
FOXBOX Tx/Rx HDMI • Remote Control 23