Extron Electronics VN-MATRIX User Guide - Manual (Page 92)

Section 5: Serial Transport & Control Methods VN-MATRIX User Guide
Page 92 I458GB issue 6
Setting-up a Remote Control Group

Decide which VN-MATRIX unit(s) will act as the remote control client(s) and connect your serial
control device(s) to the VN-MATRIX COM2 port(s) accordingly.
 Login to the Web Interface (see page 41).

From the Device List page click on the device you want to configure as a remote control client.

From the Device page click the Serial tab to display the following:
 Using the mode listbox select the client option.
 Using the destination listbox select the remote-control option.
 Change the other settings (e.g. baud rate) as required, then click the Save tab.