Imetec BELLISSIMA SENSEPIL LUX - Manual (Page 80)

EN
76
ATTENTION
It is recommended to always start the first hair removal session by setting
the lowest power level (level 1).
If you feel no discomfort during the hair removal session with the power
level set to the lowest, you can increase the power to level 2 at the next
session, and so on for each subsequent session.
Do not increase the power level if you feel an abnormal discomfort during
or after the treatment! (See “Possible side effects”).
Do not increase the power level during a hair removal session, even if no
discomfort is felt: side effects can also arise some time after the session.
SKIN COLOUR SENSOR (18)
Using the pulsed light epilation system on dark skin can cause adverse effects
such as burns, blisters and changes in the colour of the skin (hyper or hypo-
pigmentation).
The appliance has a skin colour sensor (18) that measures the tone of the
skin in the area that is to be treated at the beginning of each session and
occasionally during the session.
If the skin colour sensor (18) detects a complexion that is too dark for the
treatment, the appliance stops emitting the light pulses automatically and the
skin colour check LED (15) starts to flash.
If this occurs, try to use the appliance on another part of the body or contact
the IMETEC service centre.