Imetec BELLISSIMA SENSEPIL LUX - Manual (Page 86)

EN
82
• When the pulses are about to end, the lamp replacement LED (14) starts
flashing faster.
• When no more lamp pulses are left, the lamp replacement LED (14)
remains steady and no further pulses can be emitted: Contact the IMETEC
service centre to replace the lamp.
Note
Do not use the appliance and contact the IMETEC Service Centre if large
stains appear inside the treatment surface (17) or if this is cracked or broken.
Once the lamp has been replaced by the IMETEC Service Centre, always set
the power level to a lower one than that used normally. Increase the power
level for the subsequent session only if no abnormal discomfort is felt during
or after the treatment.