Elmo Rietschle R-VWP 500/1000/1500/2500 - Manual (Page 26)

26 | www.gd-elmorietschle.com © Gardner Denver Schopfheim GmbH, Gardner Denver Deutschland GmbH
Maintenance and repair
m n q G n
1
f H
1
H
2
K
1
K
2
s
5
s
1
I
2
q
1
7.2.3 Lubricating
NOTICE
Always change the oil when the machine is at
operating temperature and in an atmospherically
ventilated area.
If it is not completely emptied the amount that can
be refi lled is reduced.
The waste oil must be disposed of in compliance with
the local environmental protection regulations.
If you are going to use another oil type, empty the
oil removing device housing and oil cooler
completely.
Sealing oil
When the units are in continuous use the oil level in
the oil pot (Fig. 2, 3/G) should be checked daily and
the oil in the sight glasses (Fig. 2, 3/I
1
, I
2
) should be
checked weekly. The oil pot may be topped up when
the units are in operation. The oil level in the two
end cases however can only be topped up when the
units are switched off and vented to atmospheric
pressure.
Fig. 10 Lubricating VWP 500 - 1500
VWP 500 - 1500