Franklin Fueling Systems Colibri CL6 Setup and Operators Guide - Manual (Page 10)

10
Select each grade and assign a name (i.e. Unleaded
Regular).
4. Enter the number of fueling points. In this example
there are 4.
5. Select Fueling Point 1 and program the number of
hoses. For this example there are 3 available grades
at FP1 and FP2. (number of hoses =3)
and 4 grades available at FP 3 and 4 (number of
hoses = 4). Continue to enter the number of hoses
for each fueling point.
6. After the number of hoses are programmed, push
the auto-configuration button for fueling point 1.
This will allow the console to automatically program hose
information (grade association and position) for the Fueling
points based on information received from the D-box.
7. Follow the instructions on the screen.
Note: Dispensing small amounts of fuel from each hose
is required before copying the information to other
fueling points that have the same number of hoses.
Run Autoconfigure before copy.
Confirmation Screens:
This will allow the console to verify grade and fueling point
assignments.