Franklin Fueling Systems TS-DIM - Manual (Page 19)

19
DIM Diagnostics
Extensive testing and data collection is available to the user through the TS-DIM’s built-in diagnostic port, which is
physically located on the front panel of the TS-DIM (see the TS-DIM Front Panel Diagram below). Accessing the
diagnostic port requires a computer running a terminal emulation program such as Hyperterm, PuTTY or Procomm. A
physical connection is made using a serial cable (straight through). Once the connection is established, power up the
TS-DIM and a prompt will appear. To view a help menu, type ? at the prompt.
TS-DIM Front Panel View
RLM II Monitor
Cable Input
AC Input
TS-DIM Rear Panel View
Figure 16: TS-DIM End Panel Diagram
The terminal emulation program (i.e Hyperterm, PuTTY or Procomm) must be set to the following parameters to work
properly.
Baud rate 57,600
Data bits 8
Parity none
Stop bits 1
Flow control none
Terminal emulation setting ANSI
TS-DIM Power Up
When the TS-DIM powers up, the screen below will appear.
TS-DIM Help Menu (?)
The screen below shows the help menu. To display a menu of available options, simply type ? at any of the prompts. The
only section that will be needed for installation is the Diagnostic section: for information or help with any other section,
please contact Technical support.