Alpha Technologies CFR 600, CFR 600XT, CFR 1000 - Manual (Page 48)

5. RS-232 TERMINAL COMMUNICATION
5.11 Parameter Dump Command (Function 0)
Parameter Dump Command (Function 0)
Function ‘0’ displays all UPS parameters in the following format:
#####,###.#,#####,#####,##.##,###.#,#####,###.#,#####,###.#,#####,#####,##.##,
###.#,###.#,###.#,xxxxx,#####,#####,#####,#,##,##,##,##,##,##,##,##,
###############,############ <CR> <LF>
Where ‘#’ indicates a digit or a blank character and ‘x’ represents a
letter. The string is terminated by a Carriage Return and a Line Feed.
Parameters are separated by a comma (‘,’). Above is the exact format for
the SID option; IID option has slightly different format (less blank charac-
ters). This command lists the CFR parameters in the following order:
1. Input Voltage 17. Charger Status
2. Input Current 18. Battery Temperature
3. Input VA 19. Efficiency
4. Input Watts 20. Capacity
5. Input Power Factor 21. Run Time Remaining
6. Input Frequency 22. Mode Data
7. Output Voltage #1 23. Input Alarms #1
8. Output Current #1 24. Input Alarms #2
9. Output Voltage #2 25. Battery Alarms
10. Output Current #2 26. Output Alarms
11. Output Watts 27. Environmental Alarms
12. Output VA 28. Inverter Alarms
13. Output Power Factor 29. System Alarms
14. Output Frequency 30. IID/Micro Board Serial #
15. Battery Voltage 31. Unit model - config. version
16. Battery Current
Example:
114, 1.22, 133, 38, 0.29, 59.9, 127, 0.31, 222, 0.49, 95, 0, 0.00,
59.9, 55.2, 2.8,ON , 24, 0, 0, 0,00,00,00,00,00,00,00,00,
88430A000000CA,001060001000<CR><LF>
0
42
In the above example, 114 represents the Input Voltage, 1.22 repre-
sents the Input Current, 133 represents the Input VA, etc.