Alpha Technologies BPT Series Bypass Transformer - Manual (Page 24)

NOTES:
1.
The UPS will be internally configure
d for either 208V or 240V output.
Check the nameplate rating of the UPS to verify the correct voltage.
2.
Omit this connection if 120V output is not required or available.
3.
Terminal designations are shown for Standard BPT
Series.
If BPT
-S Series transformer is used, refer to label on transformer for actual terminal
designations.
Figure 6.8
System Bypass Schematic
208V IN - 120V/240V OUT
2 2
1
NO
TE 3
The Alpha BPS Series
Doc# 020-133-B0 Rev. 01 / 07
20