Alpha Technologies XP-EDH4 - Technical Manual - Manual (Page 43)

43 745-419-B0-001 Rev. A (11/2013)
You may also configure the sysName and sysLocation from the Config Web page. This feature is
password protected. There are both “Admin” and “User” User Names and Passwords. Both User
Names (Admin and User) have the authority to set sysName and sysLocation. The Passwords
can be changed via the Broadcom httpMgmt MIB. The specific OIDs and default values are
shown below.
Parameter OID Default
httpAdminId 1.3.6.1.4.1.4413.2.2.2.1.1.3.1.0 admin
httpAdminPassword 1.3.6.1.4.1.4413.2.2.2.1.1.3.2.0 cheetah
httpUserId 1.3.6.1.4.1.4413.2.2.2.1.1.3.3.0 cheetah
httpUserPassword 1.3.6.1.4.1.4413.2.2.2.1.1.3.4.0 cheetah
3.0 Configuration and Operation, continued
3.8.2 Web Page Access
To access the transponder locally using a Web browser, follow the procedure outlined below:
1. Connect a standard CAT5 Ethernet cable between the transponder and a laptop or similar
device.
2. Open a Web browser.
3. Enter the IP address 192.168.100.1 into the browser’s address field.
4. The transponder’s home page will appear.
5. Click on “Config” to select the correct power supply model (for generic models, select “ZTT
and Pre-98 Black DIN”) and IP configuration (Single or Dual IP). Click apply when the selec-
tion has been made. Refer to Table 3-4 for User Name and Password details.
Table 3-4, OIDs for Usernames and Passwords for Web Interface Access
Fig. 3-1, Configuration Web Page