Dialight RS5C4K-H StreetSense LED Roadway Sign Light Holophane Retro-Fit - Manual (Page 4)

Document No: 9100-127-1480-99 Rev A
Page 4 of 10
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 571-5778 www.dialight.com
1: Introduction
This sign light is designed for illumination of roadway sign structures. It uses the latest in solid state lighting technology for
long life, low maintenance, and high efficiency.
The unique optical design focuses light to where it is needed, giving improved efficiency over a conventional HID
luminaire.
An internal power-factor-corrected switch-mode supply allows it to be used from any nominal 120V-277V, 50/60Hz AC
supply without any variation in light output.
This lamp is suitable for use in the following locations:
• UL1598 wet locations
• Indoor and outdoor non-hazardous locations
Note: Save these instructions for future reference.
2: Installation
(NOTE: NEITHER COMPLETE FIXTURE OR RETROFIT COVER IS RECOMMENDED FOR
INVERTED OVERHEAD OR PIPE MOUNT INSTALLATIONS)
Warning:
To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected, and maintained by a
qualified electrician only, in accordance with all applicable electrical codes.
Warning:
To avoid electric shock:
• Be certain electrical power is OFF before and during installation and maintenance.
• Luminaire must be connected to a wiring system with an equipment-grounding conductor.
For supply connections use wire rated for at least 110
º
C