Dialight RS5C4K-H StreetSense LED Roadway Sign Light Holophane Retro-Fit - Manual (Page 6)

Document No: 9100-127-1480-99 Rev A
Page 6 of 10
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 571-5778 www.dialight.com
2A: Retrofit Cover Assembly Installation Instructions:
1) Open existing cover or lid assembly and discard.
2) Remove existing bulb and reflector assembly and discard per federal requirements. When cutting the existing
wire connections, be sure to maximize the length remaining with the lower unit.
3) Manufacturer recommends but does not require the removal of existing ballast, transformer, and capacitor
assemblies from existing unit.
4) Place new Retrofit Cover Assembly upside down adjacent to existing lower unit. Remove existing gasket if
attached to lower housing. Connect ground strap wire (provided) to existing lower housing ground location.
(Hardware is provided)
5) Using Gel Filled Wire nuts connect ground pigtail (supplied) and input wires from power supply (supplied) to cut
incoming power feeds on existing lower unit.
6) Connect Black wire from Power Supply to Line, Connect White wire from Power Supply to Neutral, and connect
Ground pigtail (supplied) to input ground wire.
7) Place Retrofit Cover Assembly over existing lower unit insuring wires are not pinched during installation. Ensure
LED light faces the sign structure. Center Retrofit Cover Assembly over existing lower unit. Secure Retrofit
Cover Assembly with (24) 1/4-20 screws through existing mounting holes provided in lower housing unit. Torque
hand tight. Then secure clips on rear of housing as shown. Torque 30-40 in-lbs. Finally secure front mounting
bolts 30-40 in-lbs. All required mounting hardware is provided.
8) Loop safety strap around nearest rigged structure or rigged conduit entry