Dialight LBW1C2D DuroSite LED Low Bay - Manual (Page 2)

Document No: 9100-127-1495-99 Rev A
Page 2 of 5
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com
1: Introduction
This Low Bay light is designed for illumination of industrial locations. It uses the latest in solid state
lighting technology for long life, low maintenance, and high efficiency.
The unique optical design focuses light downward to where it is needed, giving improved efficiency
over a conventional HID luminaire.
An internal power-factor-corrected switch-mode supply allows it to be used from any nominal 120V-
277V, 50/60Hz AC supply without any variation in light output.
The unit is provided with an occupancy sensor that will switch the light from off to on when motion
is detected. The sensor’s position and detection pattern is adjustable, as well as the length of time
the unit operates at full brightness.
Model LBW1C2D is suitable for use in the following locations:
• Dry Locations Only
Note: Save these instructions for future reference.
2: Installation
Warning:
To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected,
and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
Warning:
To avoid electric shock:
• Be certain electrical power is OFF before and during installation and maintenance.
• Luminaire must be connected to a wiring system with an equipment-grounding conductor.
Warning:
• Make sure the supply voltage is the same as the rated luminaire voltage.
• Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
Recommended mounting height: 12-20 feet