Dialight LBW1C2D DuroSite LED Low Bay User Manual
Page 3
Document No: 9100-127-1495-99 Rev A
Page 3 of 5
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com
Pendent Mount Installation Steps:
•
For maximum long term reliability and light output, the light must be installed in free air.
o
The Low Bay fixture design incorporates an over-temperature control circuit that
reduces input power should internal temperatures reach a maximum level. As a
result, light output may be reduced.
•
The Low Bay fixture is threaded for 3/4” NPT in order to be assembled to conduit.
o
Calculate and measure required conduit length.
o
Feed the power cable through the conduit and into the junction box.
o
Attach the fixture to the conduit (using Teflon tape or pipe sealant).
o
Insert 1/4-20 anti-rotation screw in order to secure the fixture to the conduit.
•
Connect power cable conductors as follows:
o
Green wire connects to Safety Ground.
o
White wire connects to Neutral
o
Black wire connects to Live
•
Restore power and verify operation.