Dialight HB-XXXX-EU DuroSite LED High Bay Fixture CE Ver. - Manual (Page 2)

Page 2 of 6
Dialight Europe Ltd, Exning Road, Newmarket, Suffolk, CB8 0AX
Tel: +44 1638 665161 Fax: +44 1638 660718 www.dialight.com
1: Introduction
This High Bay light is designed for illumination of industrial locations. It uses the latest in solid state
lighting technology for long life, low maintenance, and high efficiency.
The unique optical design focuses light downward to where it is needed, giving improved efficiency
over conventional HID,HPS and Induction luminaires.
An internal power-factor-corrected switch-mode supply allows it to be used at a nominal
230/240VAC, 50/60Hz AC supply without any variation in light output.
• ALWAYS REFER TO PRODUCT LABEL FOR INGRESS PROTECTION
(IP) RATING.
Note: Save these instructions for future reference.
2: Installation
Warning:
To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected,
and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
Warning:
To avoid electric shock:
• Be certain electrical power is OFF before and during installation and maintenance.
• Luminaire must be connected to a wiring system with an equipment-grounding conductor.
Warning:
To avoid premature failure and to maintain continuous operation:
• Make sure the supply voltage is the same as the rated luminaire voltage.
Do not install where the ambient temperature exceeds the marked operating temperatures.
For supply connections use suitable cable rated for 230/240V 1.5mm
2
and at least 90
º
C
Recommended mounting height: 6 to 12 metres.
Note: Lower heights effect the overall coverage area but increase the light levels on the targeted
areas