Dialight HB-XXXX-EU DuroSite LED High Bay Fixture CE Ver. User Manual
Page 3
Page 3 of 6
Dialight Europe Ltd, Exning Road, Newmarket, Suffolk, CB8 0AX
Tel:
+44 1638 665161
Fax:
+44 1638 660718
www.dialight.com
Pendent Mount Installation Steps:
•
For maximum long term reliability and light output, the light must be installed in free air.
•
The High Bay fixture design incorporates an over-temperature control circuit that reduces
input power should internal temperatures reach a maximum level. As a result, light output
may be reduced.
•
The High Bay fixture is fitted with a 3 metre long cable that can be extended if required.
•
Eyebolts or other suitable fixings with a recommended ¼ inch x 20 thread can be used to
secure to the rear of the High Bay fixture for pendent mounting.
•
Rear alignment mark should be observed when installing the oval light output version,
model types HB7XXX-EU.
Stirrup Mounting
•
When the High Bay fixture is purchased with the optional ‘Stirrup Bracket’ the luminaire
must be installed in free air.
•
The ‘Stirrup Bracket’ is fixed into place by the 2 bolts along the side of the light fixture,
when secured into the desired position the 2 bolts should be tightened to 8.0 – 10.0Nm.
Electrical Connection
•
Note: Proper electrical and installations of extension should be carried out by a qualified
electrician.
•
Connect power cable conductors as follows:
o
Green/Yellow wire connects to Safety Ground.
o
BLUE wire connects to Neutral
o
BROWN wire connects to Live
•
Restore power and verify operation.
Interfacing to an PIR or Occupancy Sensor:
The Dialight High Bay fixture is ideally suited for control by a an occupancy sensor in order to
maximize energy savings based on its instant-on behavior and low power consumption.
Instructions for connecting the High Bay fixture to an occupancy sensor are listed below.
WARNING: TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH APPROPRIATE
ELECTRICAL CODES AND REGULATIONS.
WARNING: CONTROLLING A LOAD IN EXCESS OF THE SPECIFIED RATINGS OF THE
OCCUPANCY SENSOR COULD DAMAGE THE UNIT AND POSE RISK OF FIRE, ELECTRIC
SHOCK, PERSONAL INJURY, OR DEATH. CHECK LOAD RATINGS TO DETERMINE THE
UNIT’S SUITABILITY FOR YOUR APPLICATION.
NOTE: SEE PIR/OCCUPANCY SENSOR INSTALLATION INSTRUCTIONS FOR ADDITIONAL
INFORMATION.