MoTeC ADR - Manual (Page 10)

ADR Functionality User Manual Configuration
LEDs Tab
Figure 6 – Device Configuration – Example LEDs Tab
The Intensity of each of the three LEDs on the ADR can be individually configured.
The functions of the parameters on the LEDs tab are as follows.
LED Intensity / Status /
Power/ Data Used to set the brightness (1% to 100%).
External LED / Enable
external LED Enable or disable the external LED function. Disable this function if an external
LED is not used. If not disabled, and an external LED is not used, an External
LED open circuit fault is generated.
External LED / Duty Used to set the brightness of the external LED during the power on lamp test.
Further Information:
For details on how the LEDs function; see the
LEDs section on page 12 .
MoTeC — Published: 11 February 2014 Page 9