MoTeC C125 - Manual (Page 18)

MoTeC C125 Track Kits 17
C125 loom. Plug the other end into your ECU communications connector.
3. Plug the cigarette lighter power adapter into a spare power supply socket. If
your vehicle does not have a power supply socket, cut off the adapter and
connect the red wire to a fused 12 V source and the black wire to chassis
ground.
4. Connect a laptop to the C125 using the Ethernet lead provided.
5. Start up C125 Dash Manager.
6. Select Tools > Connection settings in C125 Dash Manager, then select
Add
.
7. Select the Search button.
8. Highlight the device displayed in the connected device window, and select
the Select button.
9. Select OK on the new IP screen.
10. Select OK on the Connection settings screen.
11. Select File > New
12. Select C125 M400 M600 M800 template if you have one of those ECUs,
or select the C125 M84 template.
13. Select Online > Send Configuration to put the configuration in the Dash
14. Save the file with a new name, such as “my start file”
15. Choose yes or ok to any warnings that display while this new
configuration is sent to the Dash.
16. Power up the car, including turning on the MoTeC ECU. The number in
the top right of the display should change to show the current Engine
Temperature. NOTE: If the Engine Temperature is still not displayed, check
ECU settings as shown below.
17. The installation should now be complete.
ECU settings
Start ECU manager, and connect your UTC.
Select Adjust > General setup > Communications > CAN Setup
Set CAN 0 Data to 0
Set CAN 0 Address to 1520
Set CAN 0 Transfer Rate to 50