MoTeC C125 - Manual (Page 49)

48 Configuration MoTeC
Display Creator Settings tab
This tab is used to define page display behaviour.
Note:
The channels selected on this tab must also be included in the Display
Creator Channels list for them to be included in the DBC file for import to
Display Creator.
Number of Pages
Specifies the number of pages defined in the applicable Display Creator
configuration.
Preserve Page
If ticked and the device is power cycled, the last page that was displayed for
at least five second before the power cycle occurred will display.
If not ticked and the device is power cycled, the default page will display.
Page Channels
Specifies the channels used to set page up, down and reset values.
Page up
is the next page in numeric sequence, default channel is Display
Page Up Button.
Page down
is the previous page in numeric sequence, default channel is
Display Page Down Button.
Page reset
returns the display to the default page, default channel is Display
Page Reset Button.
Output Channels
This is used to select the output channel, which is the channel that controls
the page displayed, default channel is Display Page.
Note:
For page control to function, this channel should be included in the
Display Creator Channels list so that it is included in the DBC file for import to
Display Creator.
For example, if the output channel value is 3 (that is page 3 is displayed), it is
increased to 4 via the Display Page Button Up channel and decreased to 2 via
the Display Page Down Button channel.
Other Functions
The Display Logger can perform many other functions accessible from the
Functions menu including the following:
Shift Lights –
to configure the shift point values for use with the Shift Lights.
Shift Light Module
– to configure the C125 10 stage shift lights as well as an
additional MoTeC's SLM-C or SLM.