MoTeC C125 - Manual (Page 43)

42 Configuration MoTeC
Display Modes (Pages)
The display has three display modes; the default names are RACE,
PRACTICE and WARMUP. The mode is changed by pressing the button
assigned to this function.
The mode names can be changed to suit your individual needs; this is done
by double-clicking on the Page Label field.
RACE Page
The Race display is normally used to display minimal information, e.g. RPM,
Lap Time, Fuel Remaining or Laps Remaining.
PRACTICE Page
The Practice display is normally used to display basic information, plus
information to help the driver improve lap times, e.g. Lap Time, Lap
Gain/Loss, Maximum Straight Speed, Minimum Corner Speed or Corner Exit
Speed.
WARMUP Page
The Warm-up display is normally used to display important engine sensor
readings during engine warm-up, e.g. RPM, Battery Voltage, Engine
Temperature, Oil Pressure, Oil Temperature and Fuel Pressure.
Gain / Loss Bar
The Gain / Loss bar can be configured to graphically represent the current
value of the Lap Gain/Loss Running channel. If not configured the Gain / Loss
Bar does not display.
Example Bar / Loss Bar
This bar can be customised to suit a user's preference. For example:
• Setting the scale and the time units.
• Customise the labels at either end of the bar (in the example above, Left
and Right is used, another example is +2 and -2, where 2 is the scaling
value).
• Invert colours, that is - red or green on either side.
• Specify the negative to the left or right.