Castle TSM-21 Serial 64234 and above (Bosch) Operator Manual - Manual (Page 14)

CASTLE, INC TSM-21 OWNERS MANUAL V2.0 Page 14 of 41
3.1 Initial Configuration
Now that the machine is connected to a power source and air supply, it is suggested that you
test the machine’s controls for proper function.
Caution: Read the Operator Manual carefully before operating. Make sure that you
have followed all assembly and installation instructions correctly. Make sure that you
are familiar with the functions described in the rest of the manual as well. Failure to fol-
low this warning may result in serious injuries to persons and property.
• Turn on the Power Switch.
• Place a piece of scrap wood under the Clamp Guard against the Face Plate to depress the
Safety Buttons (Fig 5).
Fig 5 Fig 6 Fig 7
• Be sure to keep your hands clear of the clamp, and then step on the Foot Pedal. A full cycle
should take 1½ to 2 seconds.
• Inspect the pocket. If the drilled hole is off center (Fig 6), it can be centered using the
adjusting nut on the Pilot Hole Adjustment Bolt just below the drill motor. (Fig 7)
• Tightening the nut moves the drill tip left relative to the operator. Adjust accordingly.