Castle TSM-21 Serial 64234 and above (Bosch) Operator Manual - Manual (Page 17)

CASTLE, INC TSM-21 OWNERS MANUAL V2.0 Page 17 of 41
Note: If the work piece shifts noticeably during the Pocket Cycle, this usually means
the Router Feed Rate is faster than the tooling’s ability to clear the Pocket. In general
the desired Feed Rate is slower for harder, denser materials.
4.2 Pocket Web Adjustment
The offset distance from the end of the pocket to the edge of the work piece is called the “Web.”
(Fig 9) It has been factory set at approximately
7
/
8
” to accommodate 1 ½” screws.
Fig 9
If you are using 1¼” screws you may choose to shorten the Web to
5
/
8
”.
Note: The minimum recommended Web under any circumstance is 5 /
8
”.
The Web is adjusted by shortening or lengthening the travel of the router’s cutting stroke.
• Locate the Router Stop Plate nut on the right side of the yellow Clamp Guard on top of the
machine. (Fig 10)
Fig 10
Web